Filter
Top Products
9
434 Nokia Network Voyager for IPSO 4.0 Reference Guide
The default value is 60 seconds.
5. To make your changes permanent, click Save.
TCP MD5 Authentication Example
Configuring TCP MD5 Authentication on Nokia Platform A
1. Configure the interface as in “Ethernet Interfaces.”
2. Click BGP under Configuration > Routing in the tree view.
The following two steps enable BGP function on Nokia Platform A.
3. Enter
10.10.10.1 (default is the lowest IP address on the appliance) in the Router ID text
box.
4. Enter
100 in the AS number text box, then click Apply.
The following 2 steps configure the EBGP peer for Nokia Platform B.
5. Enter
200 in the Peer autonomous system number text box.
6. Select External in the Peer group type drop-down list; then click Apply.
The following steps configure an EBGP peer with MD5 authentication
7. Enter
10.10.10.2 in the Add remote peer ip address text box; then click Apply.
8. Click the 10.10.10.2 link to access the BGP peer configuration page
9. Select MD5 as the authentication type from the AuthType drop-down list; then click Apply.
10. Enter the MD5 shared key (test123 for example) in the Key text box; then click Apply.
Configuring BGP Route Redistribution on Nokia Platform B
1. Configure the interface as in “Ethernet Interfaces.”
2. Click BGP under Configuration > Routing in the tree view.
The following three steps enable BGP function on Nokia Platform B.
3. Enter
10.10.10.2 (default is the lowest IP address on the appliance) in the Router ID text
box.
4. Enter
200 in the AS number edit box; then click Apply.
The following 2 steps configure the EBGP peer for Nokia Platform B.
5. Enter
100 in the Peer autonomous system number text box.
AS100
00336
Nokia
Platform A
AS200
Nokia
Platform B
10.10.10.1/24 10.10.10.2/24
EBGP