Filter
Top Products
2
54 Nokia Network Voyager for IPSO 4.0 Reference Guide
17. In the To Remote Host section of the Authentication table, in the Password text box, enter
the password to be returned to the remote host for PAP authentication, or the secret used to
generate the challenge response for CHAP authentication.
Note
The To Remote Host information must be the same as the From Remote Host
information (or its equivalent) at the remote end of the link.
18. In the From Remote Host section of the Authentication table select the authentication
method used to authenticate the remote host.
19. In the From Remote Host section of the Authentication table, in the Name text box, enter the
name that will be returned from the remote host when this host attempts to authenticate the
remote host.
20. In the From Remote Host section of the Authentication table, in the Password text box, enter
a password to be returned by the remote host for PAP authentication, or the secret used to
validate the challenge response for CHAP authentication.
Note
The From Remote Host information must be the same as the To Remote Host
information (or its equivalent) at the remote end of the link.
Note
The Bandwidth Allocation table entries that follow allow the network administrator to
manage the parameters that are used to determine when to add or remove an additional
B-channel only when using Multilink PPP.
21. In the Bandwidth Allocation table, in the Utilization Level text box, enter a percentage
bandwidth use level at which the additional B-channel is added or removed.
When the measured use of an outgoing B-channel exceeds the utilization level threshold for
a period greater than the use period, the second B-channel is brought into operation. When
the outgoing B-channel use falls below the use level for a period greater than the value of the
use period, the second B-channel is removed from operation.
A use level of zero means that the second B-channel is never brought into operation. To
bring the second B-channel into operation quickly, set the use level to a low number, such as
one.
22. In the Bandwidth Allocation table, in the Utilization Period text box, enter the use period.
This value specifies the number of seconds the outgoing B-channel use must remain above
the use level before a second channel is brought into operation. When a second B-channel
has been added, this value specifies the number of seconds that the use of the outgoing B-
channel must be below the use level before the second B-channel is removed from
operation.