Filter
Top Products
8
348 Nokia Network Voyager for IPSO 4.0 Reference Guide
Configure PC1
You now need to set up PC1. Perform the same steps that you performed to configure Nokia
Platform 1 (IPSO), with the following changes.
1. Step 6; for the local filter, enter
192.68.26.74 in the Address text box.
2. Step 7; for the remote filter, enter
192.68.26.65 in the Address text box.
Changing the Local/Remote Address or Local/Remote Endpoint
of an IPSec Tunnel
1. Click IPSec under Configuration > Security and Access in the tree view.
2. In the Name column, click the name link for which you want to change the IP address.
Example:
tun0c1
3. You are taken to the IPSec Tunnel page.
4. (Optional) Enter the IP address of the local end of the IPSec tunnel in the Local Address text
box.
The local address must be one of the system’s interfaces and must be the same as the remote
address configured for the IPSec tunnel at the remote router.
5. (Optional) Enter the IP address of the remote end of the IPSec tunnel in the Remote Address
text box.
The remote address cannot be one of the system’s interfaces and must be the same as the
local address configured for the IPSec tunnel at the remote router.
6. Click Apply.
7. To make your changes permanent, click Save.
Removing an IPSec Tunnel
To remove an IPSec tunnel
1. Click IPSec under Security and Access in the tree view.
The IPv4 IPSec General Configuration page appears by default. If the IPv6 General
Configuration page is desired, scroll to the bottom of the page and click on the IPv6 IPSec
General Configuration link.
2. Under the IPSec Tunnel Rules heading, click in the Delete square of the tunnel name(s) you
wish to delete.
3. Click Apply.
An Apply Successful message appears and the tunnel(s) selected for deletion are removed
from the IPSec Tunnel Rules table.
4. To make your changes permanent, click Save.