Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 119
On means that all packets that egress through the tunnel will exit through the outgoing
interface (local endpoint). If the local endpoint link fails, traffic does not egress through
the tunnel.You might use this setting to prevent possible routing loops.
Off means that packets that egress through the tunnel can be routed through any
interface. Use this setting to allow the system to use a different interface in case the local
endpoint link fails.
Note
If the local endpoint is a loopback address, you must set this option to Off to allow traffic to
egress through the tunnel.
11. (Optional) Select a value from the TOS value drop-down window.
Click Apply.
On GRE tunnels, it is desirable to copy or specify the TOS bits when the router encapsulates
the packet. After you select the TOS feature, intermediate routers between the tunnel
endpoints may take advantage of the QoS features and possibly improve the routing of
important packets. By default, the TOS bits are copied from the inner IP header to the
encapsulating IP header.
If the desired TOS value is not displayed in the drop-down window, select Custom Value
from the menu.
Click Apply. An entry field appears.
12. (Optional) If you selected a custom value from the TOS value drop-down window, enter a
value in the range of 0-255.
Click Apply.
13. (Optional) Change the interface’s logical name to a more meaningful one by typing the
preferred name in the Logical name text box.
Click Apply.
14. (Optional) Add a comment to further define the logical interfaces function in the Comments
text box.
Click Apply.
15. Click Save to make your changes permanent.
To change the local or remote address or endpoint of a GRE tunnel
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. In the Logical column, click the Logical Interface link for which to change the IP address.
Example:
tun0c1
3. (Optional) Enter the IP address of the local end of the GRE tunnel in the Local address text
box.
The local address cannot be one of the systems interface addresses and must be the remote
address configured for the GRE tunnel at the remote router.