Filter
Top Products
2
114 Nokia Network Voyager for IPSO 4.0 Reference Guide
Frame Relay Protocol
To change the keepalive interval in frame relay
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column. Example:
ser-s2p1.
3. Enter a number in the Keepalive text box to configure the Frame Relay keepalive interval.
Click Apply.
This value sets the interval, in seconds, between keepalive protocol message transmissions.
These messages are used periodically to test for an active remote system.
Note
This value must be identical to the keepalive value configured on the system at the other
end of a point-to-point link, or the link state fluctuates.
4. Click Save to make your changes permanent.
To change the DLCI in frame relay
Note
To move an IP address from one PVC to another, you must first delete the logical interface
for the old PVC, then create a new logical interface for the new PVC.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column. Example:
ser-s2p1.
3. Locate the logical interface to delete in the Logical interfaces table for this device.
4. Click the corresponding Delete button.
Click Apply.
The logical interface disappears from the list. Any IP addresses configured on this interface
are also removed.
5. Enter the DLCI number in the Create a new interface DLCI text box.
Click Apply.
A new logical interface appears in the Interface column. The DLCI number appears as the
channel number in the logical interface name. The new interface is on as default.
6. Click the logical interface name to go the Interface page.
7. Enter the IP address for the local end of the PVC in the Local address text box.
8. Enter the IP address of the remote end of the PVC in the Remote address text box.
Click Apply.