Filter
Top Products
Nokia Network Voyager for IPSO 4.0 Reference Guide 75
10. In the New IP Address field, enter the appropriate IP address.
11. In the New Mask Length field, enter the appropriate value.
12. Click Apply.
13. Click Save.
Point-to-Point Link over ATM
To configure an ATM interface
Note
You cannot configure an ATM interface with an IP address until at least one logical interface
is created for the interface.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column on the Interface
Configuration page.
Example:
atm-s2p1
The Physical Interface page is displayed.
3. Select SONET or SDH as the framing format in the Physical Configuration table.
Note
SONET and SDH settings are available only if the ATM interface card supports them.
The setting should match the type of transmission network to which the interface is
connected.
4. Select Freerun or Loop Timing as the transmit clock choice in the Physical Configuration
table.
Note
The Transmit Clock settings are available only if the ATM interface card supports them.
Freerun uses the internal clock. If two ATM interfaces are directly connected, at least one of
them must use the internal clock.
Loop timing derives the transmit clock from the recovered receive clock
5. Select the VPI/VCI range in the VPI/VCI Range Configuration list box.
6. Select point-to-point in the Type list box in the Create a new LLC/SNokia Platform
RFC1483 interface section.
Enter the VPI/VCI number in the VPI/VCI text box.