Filter
Top Products
2
112 Nokia Network Voyager for IPSO 4.0 Reference Guide
Click Apply.
This value sets the interval, in seconds, between keepalive protocol message transmissions.
These messages are used periodically to test for an active remote system.
Note
This value must be identical to the keepalive value configured on the system at the other
end of a point-to-point link, or the link state fluctuates.
4. To make your changes permanent, click Save.
To change the IP address in Cisco HDLC
Note
Do not change the IP address you use in your browser to access Network Voyager. If you
do, you can no longer access the IP security platform with your browser.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the logical interface link for which to change the IP address in the Logical column.
Example:
ser-s2p1c0.
3. Delete the address from the Local address text box and from the Remote address text box.
Click Apply.
This removes the old IP address pair.
4. Enter the IP address of the local end of the connection in the Local address text box and the
IP address of the remote end of the connection in the Remote address text box.
Click Apply.
This adds the new IP address pair.
5. Click Save to make your changes permanent.
Point-to-Point Protocol
To change the keepalive interval in PPP
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Click the physical interface link to configure in the Physical column. Example:
ser-s2p1.
3. Enter a number in the Keepalive text box to configure the PPP keepalive interval.
Click Apply.
This value sets the interval, in seconds, between keepalive protocol message transmissions.
These messages are used periodically to test for an active remote system.